24 HOURS A DAY
People with field experience and product knowledge to assist you.

An epoxy coating application can literally save a vessel's life.         100% solids epoxy coating can enhance flow performance and keep tubes cleaner for longer periods of time.

Vacuum blasting is a cleaner, safer method for cleaning eroded/corroded surfaces.

THE EPOXY PROCEDURE

*Our technicians arrive on the jobsite to set up our air compressor and thoroughly blow all tubes  completely dry.

*Visqueen is spread out to protect the immediate area and surrounding equipment from dirt and debris.

*Using a patented process, the Vacu-blaster is put to work removing all rust, scale and buildup from the metal surfaces to a clean white metal SSPC-SP10.

*All cleaned surfaces are heated to draw out any additional moisture before the epoxy is applied.

*Each mixture application is applied by hand to all treated surfaces to a minimum dry thickness of 50 mils in several coats.

*All eroded areas and division plates are built up and refitted to accommodate new gaskets.

*Upon completion and setup of the epoxy (normally 24 hours) we lightly sand the gasket areas and chase all threaded bolt holes or studs to remove any residue epoxy.

*All tube ends are cleaned out and blown free of any debris.

*All spent material is picked up and the equipment room area returned to a clean condition.

*Electronic spark testing is used on request to find any pinholes in the finished product and repairs made if necessary.

*A one-year warranty is provided to you upon completion of the coating.

A few customers who have utilized our services
throughout the United States and Mexico

Special precautions are taken to protect your equipment and control panels, etc.	After blasting, the epoxy is hand applied for maximum adhesion and thickness.
The beginning stage of blasting.	The vacuum blaster at work.
The comleted product.	A McQuay/Sanyo absorber before our epoxy coating.
Grit blasting the heads.	The complete job ready for reassembly.

*Complete Retubing Services*
*Eddy Current Inspection*
*Ultrasonic Corrosion Testing*
*Machining, Dismantling*
*Tubes, Retubing Tools*
*Tube Cleaning-Rentals*
*Epoxy Coatings*
*Tube Plugs-Inserts*

Whenever servicing your centrifugal condensers or evaporators, absorption units and heat exchangers, don't forget that we are a  stocking distributor for Airetool, T.C. Wilson, Goodway and Elliott Cleaning and Retubing Tools.

We offer the following services:

EQUIPMENT RENTALS
CONDENSER CLEANING
TUBE CLEANER REPAIRS
REGASKETING
CONSULTING-DEMONSTRATIONS
DISMANTLING OF EQUIPMENT
SHELL THICKNESS INSPECTION
REMOTE VIDEO TUBE INSPECTION
SAND-GRIT BLASTING/VACUUM REMOVAL
QUALITY EDDY CURRENT INSPECTION WORLDWIDE

All of our tubes are made from high grade alloys and are produced to original manufacturer specifications.  Every tube sold is guaranteed for one year against defective materials or workmanship.  Each tube is pneumatically tested and eddy current tested.  In many cases replacing old tubes with new fin configurations or externally/internally enhanced tubes can increase the cooling capacity of your equipment.  Due to the new CFC regulations and the replacement of refrigerants, most machines will lose 7% to 20% capacity.  Replacing tubes with greater heat transfer surface can help regain those percentages lost.

  1-800-356-1932

24 HOURS A DAY
People with field experience and product knowledge to assist you.

For Information and Assistance
CALL (800) 356-1932 * (909) 613-9000 * FAX (909) 590-3446
People with field experience and product knowledge to assist you.
CONDENSER & CHILLER SERVICES, INC. * 13488 FIFTH STREET * CHINO, CALIFORNIA 91710

California Lic. No. 493008
Nevada Lic No. 41229
Washington Lic. No. CONDECSO94Q5